300 Driver

Thanks all for all your input. I have a Grayboe Phoenix 2 with bottom metal to accept ACIS mag on order. Expect an 8 week or less delivery.

I had to remove a little more than I was anticipating but still not too much. Here is a pure precision altitude opened up for a top...

I'm pretty farm boy, so I'll take a pair of dial calipers an line them up in the middle of the scope tube and the middle of the bolt...

Out of curiosity, what is your process to measure scope height? My action is round, so I take half the diameter plus my rail height and...

The bottom line is to know your powders and load them with your environment per Litz's advice. Litz, the subject matter expert, did not...

There are charts available SSgt. Some are older but most will get you some good information. I can publish what I have saved, just have...

I have plenty of RL-17s, but if folks near me want to dump their P-O-S/unstable RL-17s, I'd gladly take them out of your hands. It...

👆

I second the above cost estimate as well. You may be able to get it a little lower, but you’ll have to catch some deals. Stock ~$500...

Kim is correct. They don’t make a direct drop in for your stock. If you want drop in, see FEENIX’s comments. But your action screw...

They say... Garbage in equals garbage out. I say... If my garbage puts me on target, I'm good with it. 😁

Agree under 600 yards can do either Over 800 or near transonic definitely BC with real crono velocity That’s one of the reasons I made...

I should have noted that I did have to remove some material to make the Stockys VG fit my top release Sav 10. It was no more material...