asd9055

probably a used burris fulllfield

What does your MEASURED data say? Your actual in your rifle. BTW they are both modeling software, you need to calibrate. I ahve used QL...

90% plus on fill. Burn rate to match bullet+cartridge parameters. Book will guide powders. COAL is also a big deal unless you go by...

My preference is 90% and up, regardless of cartridge.

I have no interest in shooting past 500 yds. My rifle range only goes that far and my hunting ground only goes out to 400 yds. My...

I have used 243, 308, 25-06, 270, 30-06 AND 300 Win mag. They all worked good. For the big boys I would probably leave the 243 at home.

It then zeros again at 215 yds and 2” low at 245 yds. So you are within 2” point of impact versus scope 10 yds through 245 yds

I use a 50 yd zero on all my AR’s 15’s and 10’ I just believe it the most practical zero. An AR15 with a 2.8” over bore scope zeroed at...

50 yards, if it's for CQB (red dot) or 100 yards if it's a special purpose rifle (scope).

My AR15 is 5.56 and zeroed at 100 yards. It's main use is prairie dogs out to 300 yards with a 2-7X scope.

A good rule of thumb is the safe will only hold half of the guns advertised. As far as what is best is just a rabbit hole that you don’t...

I am happy they showed their appreciation. There is a difference between going beyond and doing something extra than stopping at a game...

Bet you're dentist never pis$ed on your venison for being a tight wad. 😁 You tip excellent work. Not something that is written, but if...

NO I never do. Do you tip your dentist, mechanic, roofer or anybody that has ever performed a service for you? Where are we going to...

If using both a muzzle brake and suppressor ( depending on situation)-- then one of the rubber donut tuners would probably work best as...