Mike D Texas

Thinning my collection Excellent shape S&W 657 no dash 41 magnum,6" barrel,hogue grips,lockup is tight and a very accurate handgun...

But...those dimensions are at different distances from the bolt face. 6.5CM .4620" is at 1.4900" from the bolt face. .460" for the...

What are the specs of your 6.5CM and loads? I agree that 100fps might not be worth a rechamber on a factory barrel. But if you start...

You say no 7mm cartridges meet what you want to do, so what are you looking to accomplish with a 7mm cartridge?

My 260AI significantly outperforms my buddy's CM, at least in terms of velocity. He runs 2780'ish in a 24" barrel and I run 2980'ish in...

I don't know but Gunwerks is really ****ing me off. I've tried 4 times to contact their customer service; 2X via contact page on their...

When I was researching dies for the 6 CM I remember SAC stating Their die was tighter at .200 and opened up a little at the...

In case no one has already said it, Tikka.

Tikka superlite comes with a fluted barrel and with hand loads is tough to beat for outa the box accuracy.

What good is centering if it doesn’t align with your zero?

His fired diameter is .278, not .268. That might be .001 over after spring back but doesn’t seem excessive. I didn’t look at the...

@derickd @Elk Hunter 338 knows his stuff and I agree with him.

I see you said that you have chosen the 300 RUM.. I build a ton of them and will tell you they will surpass a 300 prc in any barrel...

PRC is nothing other than a glorified 300WM running 3.6” OAL. I do this with my 300WM’s anyway, nothing new there… Cheers.

Some say the RUM gives trivial performance gain. Not sure where they get their data/info from but my 300 RUM & my brother’s 300 RUM...