setter

I'm about to order a Zeiss S3 6x36 scope. It has a 34mm tube and a 56mm objective. I will be mounting it on a picatinny rail. Looking...

Mikecr, I assume you did the math and I thank you for that! I was curious and actually measured the thickness of the brass at the neck...

Appears this rifle does have a tight necked chamber. SAAMI for 260 Remington neck diameter is 0.297 loaded Brass neck outside dia...

I will measure the fired piece of brass and do as you suggest. Once I get a bullet puller I may also see if I can try turning the brass...

Nothing engraved on the barrel to suggest a tight neck. That doesn't mean it isn't of course. I will be measuring the necks of fired...

I have primed cases (no powder/seated bullets) and loaded cases (with primers and powder, the ones I found out wouldn't fit in my...

Also, does anyone know what case holder I can use with my primered cases to trim them? I have the Forster which I could use, but it is...

Do you by chance know if Alpha brass is any thinner in the neck thickness than Lapua?

Yes, turned them because of a diameter problem. I am guessing then that the there is likely enough variation in loaded brass that some...

I've shot two different manufacturers ammo out of my custom 260 Rem and had no problem. I just started reloading and got some Lapua...

I'm loading/reloading 7 WSM and those cases are hard to come by these days, so I need to determine how I should treat the nickel plated...

I wasn't planning on annealing as I don't have the equipment, and I am still new and learning. I wonder if anyone knows if there is a...

bottle neck rifle cases

I am going to try using an expander mandrel for the first time and I'm still new to reloading. I did a search in this forum and found a...

I think I might start over and back off close to 2 grains to look for more potential accuracy loads.