PApa Black

An OLD saying : "If it ain't Broke , Don't Fix It !!!"

How often should you and do you deep clean your rifle barrels ? I have a couple of my trusty old Tikka T3 Tacticals one in 300 Win Mag...

You could ask any bullet makers with their reloading manuals and probably get the same response.

I asked Berger that same question: the answer is lawyers and liability.

I have wondered why the berger book always seemed to be a bit on the conservative side with their load data. This may be the reason...?

Berger bullets are very tricky to tune. That's all I shoot. In my 308s 0.160" off the lans was the spot. And they don't go to sleep...

Berger says 1:11 or faster and I'm running a 1:10 twist. This gun may very well not like the H1000 or Bergers but my SD and ES are...

I have 300 Wim Mag cases, and I need to neck down to 30 cal. for my new 30-338. Can I just resize the neck to 30 cal and go ahead and...

Ooops...I meant to say that I have 338WM brass, not 300WM. Should I use a reduced load for the fire forming? Craig

308 is always the right answer

I have a Ruger American 16” in 308 for same purpose. Shoots bug holes with 168 FGMM ammo and hand loads.

Yeah if your velocity isn’t accurate it’s a complete waste here. Get correct velocity, and make sure your zero is dead on, then start...

I just recently purchased a Tikka T3X Lite Roughtech in 6.5 PRC and mounted a VX-6HD 3-18x50 with Unknown Munitions scope rings on it...

Did you check your action screws? Are you running a muzzle device? Is it loose? Assuming factory ammo, not reloads?