newmexkid

What led you to determine that you were looking at .277 caliber bullets? Just askin'.

Nah, it'll bounce off. You probably need to step up to something more powerful like a 6.5 Creedmoor. /s

Which HH?

For everyone using the 90-92gr hammers, how did they work on coyotes? I'm in no way worried about fur friendliness. Just don't want 2...

Yeah but I bet you they are in stock when you go to order them.😉 An expensive bullet you can get is better than a cheaper one nobody...

Just a word on new brass and neck condition. I run all new brass through a custom neck die and then through a mandrel before doing any...

+1 Even if you consider that the starting pressure in the case is 14.7 PSIA, and you are squeezing the volume of the mandrel down into...

Run them through the expanding mandrel. Primed or unprimed. No difference. I have done 10s of thousands each way. NEXT time, run...

The displaced air from the expander pressuring the primer is something to consider. I have new, primed brass that I was thinking about...

You should be fine either before or after priming. The air is a compressible fluid so no worries on pressure from inserting a mandrel...

Price? I pray all ends well for you and your family. About 4 years ago I almost bought the ranch myself. In the end, I recovered and...

Prayer offered for you and yours. 🙏🏻✝️💪🏼

Yes, take care Trapper. Hope everything turns out good!

Hope all is well, or will be.

I, too, have a couple of boxes in .30 Cal to try. This is from Norma's reloading center. These powders are scarce or non-existent...