HandgunHTR

As with the others, I have had that problem in the past with Leupolds and Vortex optics. I don't use them anymore. Nightforce...

Me either.

Just an FYI, I have three Tikkas that are still in factory stocks and all three are torqued to 65 in-lbs without any issues.

Since it is a Tikka action, what I would do is swap out the bolt stop and magazines and go with a 6.5 or 7 Sherman Short. The 7SAUM is...

That may be the case if you had to pay 100% up front, but C6 only requires a 50% deposit and the rest is due upon completion.

That is some great info! Thank you very much for sharing.

Add some baking soda (about a cup) or Arm & Hammer laundry detergent (about a 1/2 cup) to your boil water to dissolve the connective...

On my two .22 cans I clean them about every 500 rounds. The centerfire cans never get cleaned. If I notice some carbon coming out of...

After it is boiled and everything is cleaned off, mix these two things together and paint it on the skull. Let it dry and then brush it...

Based on the fact that you are able to tighten up the groups with different torques on the action screws, I am of the belief that there...

One of the main issues with using QD suppressors is that a lot of the time, there isn't a foolproof way to ensure that the suppressor is...

The M658 was from back when Tikka used to make a long action (M658) and a short action (M558). They have the same quality as the Tikkas...

Except it isn't actually faith. There is science that explains it as long as you take the time to find the actual science (not take the...

I am loading up some 147 grain ELDMs for mine right now. Just haven't had time to get to the range due to the peak of the rut happening...

The reading you get on the Garmin is muzzle velocity.