VinceMule

To get away from the burnt COW in the cases. I figured the coffee was already burnt and none of the powder that COW has. It worked for me

Work up the fire form loads with Bullseye just like you would any other load to get the desired results. You will find a perfect fire...

I turn the necks at 308 or 7/08, then neck down to 243 AI. I anneal after necking down. The results are amazing. I do not know that I...

Screw Bartline! Yep, I said it. They'll never get my buisness. I've tried three times to use them over the years. First time was a...

Out of the options given, Brux.

I know nothing about doing it in a mill, but have done a few on the lathe with a LaBounty fixture. I didn't take anything off the...

2986fps in my 26" w. LAPUA 6cm SRP necked up, Fed GM205M, and 135s over 42.4gr H4350.

I found that cci 250s responded with very low SD and ES with all of those powders.

Roll crimping reduces pressure by approximately 8000 LUP. I have been loading buckshot since the 80's when Ballistic's Products first...

IBTL

Peterson brass is thicker, meaning less case capacity. Less case capacity w. same powder charge = more pressure = more velocity. Also...

Just imagine the cost of TSS on 200 rounds!

Add the additional buffer if needed. Pressure signs are just like rifle pressure signs, rim will bulge or get thicker, lettering will...

WD-40 is the worse thing you can use on a firearm it gums up JUNK

I store my guns muzzle down....