DirtNap35

When shooting suppressed vs muzzle brake you will have an increase in recoil when shooting suppressed, it's just physics. I got a 8 lb...

I smell a potential chamber issue ... a "small" issue can go unnoticed with ammo that is not pushing pressure limits whereas higher...

Throwing this up to see if there is any interest. I don't need a 338, not that I don't have other rifles that I don't need either. Bat...

LPR 7PRC BAT LPR HR lightweight action Carbon bolt knob Hells canyon 24" 8 Tw carbon 4 port Ghost brake Hawkins hunter DBM w/one...

I noticed I have this mark on fired ADG brass and the exact same mark on factory ammo. Any ideas what that is from?

@Marky_mark do you think carbon ring would have anything to do with it? I wouldn’t think so since it’s only a here and there

Good info

https://www.wheeleraccuracy.com/videos lots of info here do your die fit your chamber is a good one same with te clicker one

I measured the two cases I didn’t shoot because of resistance when trying to shut bolt. The measurements at Dantum, headspace, and COL...

Using Redding Type S Match.

@FireFlyFishing factory shot great. No pressures, no hard bolt in or out, and shot .3 MOA. I think you’re right I’m going to start...

After firing it's .5335 and after resizing .532 Virgin brass is .529

Well I’m here to eat crow. My reloading practices are apparently ****. I’m at a lost of what's causing spikes in pressure. I reduced...

May have to move the Reaper I picked up here not all that long ago. Need some bill paying money. 175 rounds slow fired by previous...