.300 Dakota

Yeah the LRX seems to lack one or two of the grooves of the TSX/TTSX, so there is more bearing surface there, even compared to other...

I'm going to go a bit slower. My 6.5 PRC did VERY well with Magnum, so I see no reason N568, LRT, and StaBall HD shouldn't work equally...

I loaded up 58,58.5 and 59gr of N565 and 57,57.5 and 58gr of H1000 to test. I am running 58gr of N565 and 57gr of H1000 in my 25PRC with...

They were thinking about starting on mine a week or so ago and ran into an issue with what I ordered. Got on the phone and got it...

My barrel should be here Saturday so hopefully Sunday I can go test some loads.

I'm going to stop posting in this thread and I'll submit an article with photos and a range report when done. I think that would be the...

You have a plan for loading. I like it. Certainly want to hear your progress during break in and load development.

At any rate, regardless of who got what from the old manufacturing, the NEW manufacturing chamber seems to be on the less sloppy side. I...

Probably after you left unless you JUST left. We all know quality went downhill more towards the bankruptcy.🤷‍♂️

This is what Remington always claimed, fired at the factory pre-new design. Until I received two brand new in the box 700's WITH NO...

Bumping once more before moving elsewhere.

MBM (Muzzle Brakes and More) will turn a brake to your dimension if you contact him.

Also need brake recommendations. Don't really want to disassemble the rifle to have my gunsmith install one to match the .740" contour...

Here's a shot in my Remarms 700 ADL. This is Remington's cheapest 700 in their line up. Yours is basically their flagship model. I'd...

Yessir, I got it cleaned up without a Dremel. Yes, I knew the factory fired them, but I was thinking it looked like maybe just a little...