Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Equipment Discussions
Wilson vs Redding vs Forster?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Trickymissfit" data-source="post: 627898" data-attributes="member: 25383"><p>just pulling straws out of the stack, but you might want to take a look at the O.D. verses the I.D. on a couple fired cases that have not been resized. Then do the samething after running them thru the die. I'm kinda wondering if your not "over sizing" the brass somehow or another. If your using a bushing, you need to check the amount of tension after seating the bullet. Three to four thousandths is about right, and anything tighter means the neck is in a very tight bind going thru the sizer. I don't shoot a 6.5 anything anymore, and the closest thing to what you have is a 6mm Remington. I ran the cases thru a Wilson die at the range about six or eight times than ran them the a Forster full length die. I never saw a doughnut! In my 6/250AI I will get a doughnut after about five or six firings, but I also associate that with the 40 degree shoulder angle. </p><p>gary</p></blockquote><p></p>
[QUOTE="Trickymissfit, post: 627898, member: 25383"] just pulling straws out of the stack, but you might want to take a look at the O.D. verses the I.D. on a couple fired cases that have not been resized. Then do the samething after running them thru the die. I'm kinda wondering if your not "over sizing" the brass somehow or another. If your using a bushing, you need to check the amount of tension after seating the bullet. Three to four thousandths is about right, and anything tighter means the neck is in a very tight bind going thru the sizer. I don't shoot a 6.5 anything anymore, and the closest thing to what you have is a 6mm Remington. I ran the cases thru a Wilson die at the range about six or eight times than ran them the a Forster full length die. I never saw a doughnut! In my 6/250AI I will get a doughnut after about five or six firings, but I also associate that with the 40 degree shoulder angle. gary [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Equipment Discussions
Wilson vs Redding vs Forster?
Top