Velocity effects of barrel length

Firecat

Well-Known Member
Joined
Jan 10, 2010
Messages
406
Location
So. Utah
How much can one expect the velocity to change per inch of barrel? This is mainly asked in the realm of Magnum Calibers(7mm Rem, or 300Win). For example if a reloading manual states velocities achieved using a 26 inch barrel and your rifle only has a 24 inch barrel, how does one estimate the change in velocity. I don't have a chronograph yet so a ball park figure would be nice to know about any given load.
 
How much can one expect the velocity to change per inch of barrel? This is mainly asked in the realm of Magnum Calibers(7mm Rem, or 300Win). For example if a reloading manual states velocities achieved using a 26 inch barrel and your rifle only has a 24 inch barrel, how does one estimate the change in velocity. I don't have a chronograph yet so a ball park figure would be nice to know about any given load.

Typically the magnums benefit from extra barrel length because of lots of slower burning
powders that they use.

The cases with less than 50 grains of case capacity can use shorter barrels.

So the magnums will lose about 30 to 40 ft/sec for each inch of barrel loss. so you should
lose about 50 to 60 ft/sec going from a 26" to a 24" barrel on the 300 Win.

These velocities will vary some depending on type of powder and the barrel and chamber
combination.

J E CUSTOM
 
Typically the magnums benefit from extra barrel length because of lots of slower burning
powders that they use.

The cases with less than 50 grains of case capacity can use shorter barrels.

So the magnums will lose about 30 to 40 ft/sec for each inch of barrel loss. so you should
lose about 50 to 60 ft/sec going from a 26" to a 24" barrel on the 300 Win.

These velocities will vary some depending on type of powder and the barrel and chamber
combination.

J E CUSTOM

+1 with JE, very well said.
 
Warning! This thread is more than 15 years ago old.
It's likely that no further discussion is required, in which case we recommend starting a new thread. If however you feel your response is required you can still do so.
Top