Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Hunting
Coyote Hunting - From 10 Yards to over 1,000 Yards
Ramblings and Such From Hunting Coyote
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="DSheetz" data-source="post: 3070116" data-attributes="member: 91783"><p>Thank You Ed; The spring tips did have some rough edges on them but laying them on my ceramic stone and a few strokes took care of the sharp points from where the metal had been sheared in the manufacturing process. The edge that rides on the sear was especially rough where they stamped out the notch. I noticed that on the hammers sides it has a couple of high spots that are hanging up, well dragging so I laid it down flat on my ceramic stone and polished them till they stopped being rough on working the hammer as well. I don't want to have a hammer follow through by making my spring too light or having it let the hammer fall when hit without the grip safety engaged. A little bit goes a long way as they say. In tinkering with the old spring I had it to the point of the hammer following the slide back, but I reset the bow and got that taken care of. I think it's a good learning experience and am enjoying it. shinny spots have a story to tell you if you take the time to look listen and think about what caused them!</p></blockquote><p></p>
[QUOTE="DSheetz, post: 3070116, member: 91783"] Thank You Ed; The spring tips did have some rough edges on them but laying them on my ceramic stone and a few strokes took care of the sharp points from where the metal had been sheared in the manufacturing process. The edge that rides on the sear was especially rough where they stamped out the notch. I noticed that on the hammers sides it has a couple of high spots that are hanging up, well dragging so I laid it down flat on my ceramic stone and polished them till they stopped being rough on working the hammer as well. I don't want to have a hammer follow through by making my spring too light or having it let the hammer fall when hit without the grip safety engaged. A little bit goes a long way as they say. In tinkering with the old spring I had it to the point of the hammer following the slide back, but I reset the bow and got that taken care of. I think it's a good learning experience and am enjoying it. shinny spots have a story to tell you if you take the time to look listen and think about what caused them! [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Hunting
Coyote Hunting - From 10 Yards to over 1,000 Yards
Ramblings and Such From Hunting Coyote
Top