Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
7mm STW
How Many Loads You Get Out of Your Brass?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Mike Matteson" data-source="post: 2583397" data-attributes="member: 101791"><p>I would try neck sizing, and stopping short of sizing the full neck. That what I did a long time ago. How I came across it was I shot a 308NM chamber. To the shoulder is shorter than the 300WM case. At the time I could get a Neck sizing die for the 308NM. So I use the 300 WM neck die. That would only let neck size about half of the neck. I don't recall any problem in chambering the cases either with the 300WM neck sizing die. That ended the separation. So I would try using a neck sizing die, and don't size the entire neck. See how that works out for you. I get 3320fps with an 165gr bullet, with 75.5 grs of H4350, primes is a Fed 210. A friend of mine was getting 3400fps in 300 WM with about the same load. So I was loading hot. Primer pocket became the problem after that. Believe me I check after each firing of my cases.</p></blockquote><p></p>
[QUOTE="Mike Matteson, post: 2583397, member: 101791"] I would try neck sizing, and stopping short of sizing the full neck. That what I did a long time ago. How I came across it was I shot a 308NM chamber. To the shoulder is shorter than the 300WM case. At the time I could get a Neck sizing die for the 308NM. So I use the 300 WM neck die. That would only let neck size about half of the neck. I don't recall any problem in chambering the cases either with the 300WM neck sizing die. That ended the separation. So I would try using a neck sizing die, and don't size the entire neck. See how that works out for you. I get 3320fps with an 165gr bullet, with 75.5 grs of H4350, primes is a Fed 210. A friend of mine was getting 3400fps in 300 WM with about the same load. So I was loading hot. Primer pocket became the problem after that. Believe me I check after each firing of my cases. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
7mm STW
How Many Loads You Get Out of Your Brass?
Top