Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Gunsmithing lathe?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="gunnermhr" data-source="post: 1407892" data-attributes="member: 3457"><p>Mine is about ready to go, First thing I did was replace the belt with a Kevlar 28" x 5/8". What "Special" Belt did you use? And if you don't mind me asking, specifically what isolation mount did you use. I purchased some for my old Heavy 10 SB that were too flexible. When I put tension on the belt it cocked the motor sideways. I got a good deal on a single phase version and am seriously considering buying a 3 Phase motor and a VFD, if for nothing else to get the RPM's around 45. </p><p></p><p>I grouted it to the floor this weekend, what little vibration it had is almost non existent.</p></blockquote><p></p>
[QUOTE="gunnermhr, post: 1407892, member: 3457"] Mine is about ready to go, First thing I did was replace the belt with a Kevlar 28" x 5/8". What "Special" Belt did you use? And if you don't mind me asking, specifically what isolation mount did you use. I purchased some for my old Heavy 10 SB that were too flexible. When I put tension on the belt it cocked the motor sideways. I got a good deal on a single phase version and am seriously considering buying a 3 Phase motor and a VFD, if for nothing else to get the RPM's around 45. I grouted it to the floor this weekend, what little vibration it had is almost non existent. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Gunsmithing lathe?
Top