Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
extractor tearing brass
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="winmag" data-source="post: 392204" data-attributes="member: 22166"><p>Not nesicarily. I found that that was MY only solution. There are a bunch of Very knowledgable hand loaders that still think its the way I sized the cases. I may just be too dumb or too poor to figure it out without destroying $100 worth of brass. The guys giving me the advise were well respected guys on this site. Thier wisdom still has merit, and is far beyond mine. But I went with new brass and new dies for each rifle, and it works well. I just dont mix the brass. Its all trimmed to the same length etc. And labled the same so its kept in a seperate cupboard, and only loaded for 1 rifle at a time. Too confusing if I get both on the table.</p><p>I here ya on the muzzle loader thing. Gets to your head while your shooting, and your ''finess'' goes to crap. I may have just taken the easy (and less expensive) way out.</p><p>Try fiddeling some more with your dies. If it works PLEASE tell me how you did it. If not, then buy seperate dies and brass. Maybe some of the same folks will read this and chime in and explain how to size brass smaller than ''crushing'' it without actually crushing it.................... to ''saami spec'' I know I couldnt figure it out. I tried bumping the shoulder etc. I resized to where I turned the strait angle shoulder into a rounded ''weatherby looking variation'' and absolutely crushed some others. No it wasnt a case of too much lube. I dont know. Thats why I went the route I did.</p></blockquote><p></p>
[QUOTE="winmag, post: 392204, member: 22166"] Not nesicarily. I found that that was MY only solution. There are a bunch of Very knowledgable hand loaders that still think its the way I sized the cases. I may just be too dumb or too poor to figure it out without destroying $100 worth of brass. The guys giving me the advise were well respected guys on this site. Thier wisdom still has merit, and is far beyond mine. But I went with new brass and new dies for each rifle, and it works well. I just dont mix the brass. Its all trimmed to the same length etc. And labled the same so its kept in a seperate cupboard, and only loaded for 1 rifle at a time. Too confusing if I get both on the table. I here ya on the muzzle loader thing. Gets to your head while your shooting, and your ''finess'' goes to crap. I may have just taken the easy (and less expensive) way out. Try fiddeling some more with your dies. If it works PLEASE tell me how you did it. If not, then buy seperate dies and brass. Maybe some of the same folks will read this and chime in and explain how to size brass smaller than ''crushing'' it without actually crushing it.................... to ''saami spec'' I know I couldnt figure it out. I tried bumping the shoulder etc. I resized to where I turned the strait angle shoulder into a rounded ''weatherby looking variation'' and absolutely crushed some others. No it wasnt a case of too much lube. I dont know. Thats why I went the route I did. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
extractor tearing brass
Top