Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Chambering a rifle at home
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="ThrdKllr" data-source="post: 1779491" data-attributes="member: 110734"><p>The way I checked mine was I screwed the barrel in until it hit the bolt face. Put a mark on it, unscrewed the barrel, inserted the go gauge and screwed the barrel down to it. 20 tpi is.050 so a quarter of a turn is .0125. Set mine on about 3/16 of a turn which is right at.010. </p><p>I used a PTG bolt head on my bolt and they are deeper than the Savage bolt head. I don't have a factory pull off to fit my go gauge in to measure the factory protrusion.</p></blockquote><p></p>
[QUOTE="ThrdKllr, post: 1779491, member: 110734"] The way I checked mine was I screwed the barrel in until it hit the bolt face. Put a mark on it, unscrewed the barrel, inserted the go gauge and screwed the barrel down to it. 20 tpi is.050 so a quarter of a turn is .0125. Set mine on about 3/16 of a turn which is right at.010. I used a PTG bolt head on my bolt and they are deeper than the Savage bolt head. I don’t have a factory pull off to fit my go gauge in to measure the factory protrusion. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Chambering a rifle at home
Top