Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
7 mag brass problem
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="sedancowboy" data-source="post: 1544168" data-attributes="member: 85874"><p>We need lots more info. Is that where the die is scraping the brass from the shell as you push it into the die? If so perhaps you have a bad shell holder and is not aligning with the die? or maybe the shell holder is not fully seated in the press ram. if the scrape does not go all the way around them something is out of align. Check the die bottom and see if the edge is sharp? It would be the edge past the belt relief.</p></blockquote><p></p>
[QUOTE="sedancowboy, post: 1544168, member: 85874"] We need lots more info. Is that where the die is scraping the brass from the shell as you push it into the die? If so perhaps you have a bad shell holder and is not aligning with the die? or maybe the shell holder is not fully seated in the press ram. if the scrape does not go all the way around them something is out of align. Check the die bottom and see if the edge is sharp? It would be the edge past the belt relief. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
7 mag brass problem
Top