Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
35mm Lapping Bar
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="tobnpr" data-source="post: 2937386" data-attributes="member: 68758"><p>Fuhgeddaboutit.</p><p>The drill rod is .003 smaller- that's a mile when it comes to what you're trying to do. It'll just slide around like a bolt in the receiver, and you'll remove material unevenly all around both rings. Lapping rod needs to be precisely the diameter of the scope tube the rings are designed to fit, and needing to remove any more than a few thousandths (which will oversize the rings) is indicative of a problem that can't be properly fixed by lapping.</p></blockquote><p></p>
[QUOTE="tobnpr, post: 2937386, member: 68758"] Fuhgeddaboutit. The drill rod is .003 smaller- that's a mile when it comes to what you're trying to do. It'll just slide around like a bolt in the receiver, and you'll remove material unevenly all around both rings. Lapping rod needs to be precisely the diameter of the scope tube the rings are designed to fit, and needing to remove any more than a few thousandths (which will oversize the rings) is indicative of a problem that can't be properly fixed by lapping. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
35mm Lapping Bar
Top