Recent content by thedoveshooter

I've got one of these Husqvarna 640 (civilian M96 action) in 8x57 and its a great rifle. Handles good in the field and hits hard. I put a Weaver K6 on mine and its a perfect scope for it.

I'm about to start working on loads for my Grendel as well. Has anyone tried Ramshot Tac?

Dang. I checked them about 45 minutes before your post and there was no H4350. A tad too early!

Looking for a box of Nosler Partitions .30 cl. 165 grain for my 300 H&H. Would consider less than full box as well. Thanks

Found some at a gun show today. Very surprised. Thanks

Thanks! I looked online, but never came across that.

Looking for some 300 H&H brass. Might consider ammo too. Thanks

Y’all are right. I was thinking that but sait it wrong. Lol. I’ve got all three powders. Need to decide which to try. Thanks

First time working up a load from scratch. I’ve always worked from reloading manuals, so this is a new learning experience. Working slow and easy. Lol .264 Win Mag Interarms Mark X 26” Douglas Barrel 1-8” twist Norma Brass (new) CCI 250 primers 123 gr Absolute Ladder tested with Ramshot...

The wind was in my face. I noticed powder on my paper for notes.

It was slightly, but not bad.

This was the first powder I tried with my new .264 Win Mag. Long story short, too slow burning out of my 26" barrel. When I did my ladder test it was great. I saw pressure at 80 grains @ 3500 fps. I loaded two test loads at 79 and 79.5 gr and shot one week later. My velocities were 120 fps...

Looking for 1-2 lbs of Ramshot Magnum. I have to trade: 1 lb IMR 7828ssc 2 lbs N570 1 lb Reloder 26 I’m in Tomball.

10ring.com

10Ring has some new stock. Pic was stock as of yesterday.