Recent content by slee

Near mounts. The best mounts I have ever seen!

I have a Mark V that I customized over the last couple years and it is a great shooter. It is my everyday hunting rifle. Mark V action. with the stock fluted 26" barrel. McMillan stock , I free floated and glass bedded the action $450 stock,$25 for bedding kit Timney trigger set to 2lbs $125...

No problem, And good luck with the Accubonds. I wanted to use them as my hunting bullet, but after a few hundred rounds of testing I could not find a load that was less then 2moa. Please post your results. Always interesting to see how other guys make out.

My 3oo bee took a bit of work to figure out. At the end of the day my go to load now is 180grn TXS 84grn H4831sc Fed 215 RP brass COAL 3.562" 3150 ft/sec It's a .3moa load out of my Mark V UL. 26". I have given this load to a few other Mark V shooters with similar results. But I do have to...

I have this rangefinder as well, Great toll and the best RF I have used. Great buy!

I have the same die set for my 3oobee. They are the best I have used!

This is my go to mountain gun. It's a Mark V UL chambered in 3oowby. McMillan Stock, glass bedded and free floated Timney Trigger set to 2lbs Near 10moa Alphamounts Swarovski Z5 3.5-18x44 plex BT Weighs in @ 8lbs even fully outfitted. It's shooting 180grn TSX @ 3150ft/sec. Furthest kill shot...

her she is

Well the Near alphamounts came in the mail this morning. I reinstalled my scope with them and headed out to the range. The 10moa bases gave me enough adjustment to get out to 1000M with another 3moa of elevation left. More then I need. I have to say I use to think Talley rings were nice, but...

I have found book specs for COAL (3.562") gives me the best accuracy with my 3oobee, no matter the bullet/powder combo.

Well I just got off the phone with Richard of Near Mfg. What a great guy and I can't wait to get my Alphamounts from him next week.

I was looking at Near bases but unable to find out if he makes 1" rings? All I can find is 30mm and 34mm.... I have tried calling without any luck. Thanks for the info!

Thanks for the info! I'll have a look around to see what my options are for mfg. Thanks.

I have a Swarovski Z5 3.5-18 x 44 BT mounted with Talley low one piece rings/bases on my Mark V. With my scope zeroed at 100m I only have 10 moa of up adjustment left in the turret. With the Ballistic turret set up I can only get my scope zeroed to 500m before the turret maxes out. Is there any...

My 3oo bee always flattens primers no matter the load.