Recent content by sambo

REALLY NICE PAIR http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&item=3655103293&category=31711&sspagename=STRK%3AMESSE%3AIT&rd=1

i'm interested, i got like new remington 700 ltr. in 308 winchester with a leupold 6x42. 5 shots group under .55 inch.let me know. i live in the dfw area in texas sam [email protected]

like new, no ring marks and comes with all the original stuff. extra compensatiom cam( made by s&b)for the 308 winchester. asking $1150 delivered/ new cost around $1500 let me know [email protected] dallas texas

thanks guys for your replies, i went ahead and ordered the rifleshooter and handloader magazines. i was getting tired from paying top dollars for off the rack magazines. i know the information in this message board and others are much better than any subscription you can buy. thanks again sambo

what magazines you read for reloading and shooting. i'm looking for the most informative ones thanks sambo

the max. oal for the 40 gr. ballistic tip nosler in my savage 112fvss in 22-250 rem. is 2.522 inch. i tried to seat it .010 off the land, but when i seated it at 2.512 it was barely in, so my question is what do you do in a situation like this. do you keep seating it deeper until you feel that...

yesterday was the first day i use a F1 shooting chrony. using 50 gr. v-max bullets for my 22-250 rem. with 35.1 gr.of imr 4064 i got the following velocities 1# 3608 fps 2#3652 fps 3#3725 fps 4#3710 fps 5#3694 fps the extreme spread was 118 fps.. is that an acceptable spread, or is velocity...

guys what you all think about the new line from leupold, i've just bought the 4.5-14x50 tactical long range with the 30 m.m. tube and side focus piece. do you all think i should have waited for the new line? is there any difference between both scopes beside the m1 taurret sambo

i'va just found an article about rate of twist and the proper bullets for that twist. i own a savage 22-250 with 1 in 12 rate of twist. so according to the formula i found, my favoritev 50 and the 55 gr.hornady v-max bullets will work best in a rifle with 1-9 rate of twist and not with mine. so...

i did send you an email, let me know sambo

thanks milanuk for your reply. my next question is if i started neck sizing the cases after the first full sizing, do i still need to worry about the headspace measurment? i have never neck sized, i'm still trying to get my equipments in order. sambo [ 01-26-2003: Message edited by: sambo ]

i'm looking to get an headspace gauge for sevaral of my guns. i really never paid attention to the headspace measurments before. is the headspace gauge is a tool to tell you if you are oversizing your cases when you compare them to an actual case that has been fired in that particular gun? and...

Thanks guys for the info, that's excactly what i'm looking for. i like that site a lot. is the sight height around 1.5 in most cases? or is it more for the 50 objective lense scope? sambo [ 01-13-2003: Message edited by: sambo ]

got a quick question about shooting at different long range targets, do you all use a ballastic software to calculate the bullet drop at various distances and how would you go about using it in the field? like do you write it down on a paper and stick to the side of the stock or what? i see most...

i'm looking for a tripod or a stand to go in the bed of my kawasaki mule 3010. i've seen one at a hunting show in dallas 2 years ago before i got my mule. if anybody has any info, post here or email me at [email protected] thanks sambo