Recent content by Nitroman

Thank you!

Wondering where I can get some covers for my Springfield Armory 4-14x56mm which has an enormous 2.793" objective (70.9mm) and 1.792" (45.5mm) eyepiece?

Precision Matthews 14x40GT in 3-phase and wired it up to a rotary phase convertor. LOTS of info on YT regarding this lathe.

I KNOW Nightforce made these. Rare as hens teeth I guess, but still out there. If you have one, I have the cash....

Still looking for this.

Greetings! Looking for a Nightforce NXS 3.5-15 LV.5 with the C393 reticle for my .308. Condition isn't really a concern, but the glass must be flawless, and Zero-Stop would be nice. Let me know! Thanks.

Bump. Still seeking this scope.

"Spectacular" can mean several things. HA! Coming to you 150 miles from Nunivak Island.

Greetings, Title says it all: I need a Nightforce LV.5 with the C393 or C356 reticle for my .308. Would prefer with Zero-Stop, but will look at it if not. Cosmetic condition not really critical but glass must be flawless; scope ring marks are okay just as long as you haven't crushed the 'scope...

No. Low pressure loads allow movement of the case at the firing pin impact to the front of the chamber, as the case swells and pressure builds, the primer can be pushed back, then as the case stretches to the face of the bolt, a tiny bit of primer cup metal can extrude into the firing pin hole...

Very nice photo and analysis. If I had a good camera, I'd show the cases of factory .223 WSSM; flat primers, a little lip around the firing pin indentation, but no ejector marks. "Pressure signs" can be subjective if you have soft or hard brass. Only way to know is to use Pressure Trace...

I have a 300 RUM with 29.5" Krieger barrel 1:10 using 210 OTM at 3150fps under 60k psi. You can do it.

Thank you! I need to get back over there, but I end up spending too much money! I bought the 3-phase PM 1440 since I'll get a better surface finish over the single-phase. Added an American rotary 10hp that'll pull the 3hp lathe motor no problems. Quite a few installs on YT that show my exact...

I was going to buy a Monarch 21x78" CBB but I agonized for six months on the tiny spindle bore. And the fact that the spindle is nearly 36" long. I REALLY wanted that lathe. $22,000 plus $8,000 shipping. After doing a couple of years of research, spent lots of time talking on the phone with...

www.shootingsoftware.com/pressure.htm