Thanks everyone I do fullsize new brass first and will before I turn the necks on once fired.for some reason though I turned some new brass and they didnt group as well as the not. I didnt lube the neck and used a drill to spin them(slowly).so I redid some with lube and by hand hopefully they...
I did use a slow setting wood glue and yes you have to be very careful when you pace it in the mold.after its dry it comes out like a bent phone book if you know what I mean.the layers don't line up because the radius of the outside layer is different from the inside,so then you have to trim it...
basically finished had a few days off so I got after it. just needs a coat of varathane then its done. not quite the same stain but as close as I could get.
I need to cut to vertical slots about 2 inches apart or so and each 1 1/2 to 2 inches long then drill 2 holes to line up to the slots and bolt it to the stock with alen head type bolts.
I'm sorry I don't have the time to make and sell them.I work in the oil field and I'm out of town 95% of the time,but maybe if things slow down in the future I could make a few.As far as moisture that I don't know yet but I am using a danish oil on mine and if it was to be used in a wet climate...
I just used thin sheet metal and bent it over the mold the placed the veneer over the mold and pressed it together with the steel and some ratchet straps.let it set for at least 24h.
one picture is before I trimmed it one after I used 8 layers of walnut 1/16 veneer and topped it with one layer of cherry then I glued them all together and put them in a mold I made.when the glue dried it was solid as plywood.I still have to cut in the adjustment slots and stain it to match the...
I read an artical in the latest RIFLE SHOOTER mag new products for 2011 and they said hornady was making .22cal 53,70g GMX bullets but I can't find them on there sight anyone read the same artical or seen any?
anyone have one or used one(tubb4 way adjustable butt plate) are they any good or junk thinking of buying one for my savage 12bvss .223 any advice appreciated.
fitch thanks for the info,but would it work to shorten the mag tang like you did but instead of lengthening the pillars could I notch the stock so the tang drops down or would the mag bottom out before i could get proper clearance