Recent content by luke5678

Okay. Thank you

Running a new AR-10 with a suppressor. Got gas adjusted just enough to cycle well. Brass comes out very dirty. Tumbling helps but lots of carbon on brass. Got the idea to use some boretech eliminator-carbon remover. Worked like a charm, the black residue just wiped off the fired brass with my...

Per discussion this is sold

Do you mind sending some pics to me?

Per our conversation I will take it. Thank you

Is the rifle still for sale?

Round count please. Also, factory rem barrel? action work, etc? Thanks

Sure. For my rifle it is 77.5 grains of H1000. 2940 fps. It's safe in my gun but please work up to it and double check the nosler reloading book too. The Norma brass was the game changer in two of my rifles. Really like it and more accurate for me. Good luck and be careful

My load is Norma brass, 200 accubond .005 off lands, cci mag primer, h1000. .5 MOA Works good in mine. About 2950 fps

Any scratches on the glass? Thanks

200 grain accubond Norma brass h1000 Seat .005 off lands Runs about 2930 fps in mine Low rings with 5-22x50 nightforce. 56mm will be close, maybe mediums. MOAR reticle or npr1. NF rings and rail This is my 300 which is very similar to your described

Thank you for the feedback. I like the Tikka but any feedback on the kimber model that is similar?

I am looking at getting a lightweight rifle in 270 WSM. Any recommendations on a good factory rifle for quality and accuracy? Thanks

Headed there end of September or early October. Took a few points to draw. Anyone been there or have any advise on where to go and stuff to pack other than obvious items?

I was reloading my 300 win mag with 200 accubonds and had to switch boxes midway through. I noticed when I switched boxes I was seating .006 deeper than before due to different batch of bullets. I adjusted dies out and fixed it. I have never had this happen before. Is this normal and will it...