Separate names with a comma.
This gun is sold. To me. I guess @LeHi71 forgot to mark it.
What dok7mm said!
I now use mandrel to set final neck ID.
I use an oversize mandrel (.002 over bullet) to set a smooth ID, then neck turn. No...
Yup, then it's sintering.
12.8 is good. %13 ish increase for the same volume. Great!
That would make a Sierra Matchking 375/350 grain come out...
Oh. We were 100 down from 110 yesterday.
Caring for the "farm" in the heat means no range time.
What is the "density" of your compound? Pb is ~11.34, W is ~19.25.
Jacketed lead projectiles are less than ~11.34 because the Cu jacket is...
For the guys that said they get the Berger Classics to work. Check their ASL (altitude above sea level). I shoot at sea level so I can't "stretch"...
The challenge with these sorts of threads is that:
1) we loose the original poster with the first page or two. Our rhetoric about what is good,...
Federal 215s 215Ms if you can get them.
My basic load for almost any Weatherby chambering is IMR7828 over Federal 215 or 215Ms. Not always but...
The berm is a little close and I think the 50s are gonna damage the fence.
While they are fighting about other useless things.
Some of the old old design short nose, soft point flat base bullets will stabilized up to 100...
Steve had a great suggestion, some other forum could be better for you.
115 DTACs take a 7.75 I believe.
BC is a big deal. When added to fps, it rules.
Simple, because we can.
No one is building a better mouse trap in firearms by much until we change the technology completely. Like you said...