Recent content by Doghunter23

Now I have like ten partial boxes of 338 I should try and sell. Ranging from 250 grain to barnes copper.

I have kinda just given up on the idea, after trying many different bullets I found a 200 grain speer hot core that will shoot 1 3/4 inch groups not great but best it will do. The ruger has been relegated to bear defense sitting on a display rack just waiting for old yogi to to try and get...

your right! I have an ms180 ms270 and ms441, the only one with m-tronic is the 441. I got the number thing all wrong. I just saw the second gen electronic coming out on some models designated with a 2 for last digit. If you can adjust the carb it’s not M-tronic. I have a 36 inch bar for the 441...

The way to tell if its electronic or not is in the third number if it ends in a zero- no electronic a 1 or 2 first or second generation electronic. 390 none 391 first generation and so on. I have had to remove several large oaks near the house two of which were leaning bad to the house. I used...

https://blog.stihl.co.uk/perform-m-tronic-reset/ Gotta do an M-tronic reset! Stihl saws are electric controlled I have a MS 441 and after running a few tanks through it I could not get it to start for any thing, even when it would fire it would immediately die. I was very upset after spending...

Update, came right out with the punch. Replacement took 5 minutes, just don’t let tiny spring go flying.

And Winchester won’t share any information.

Information on this shotgun is nonexistent online.

I broke my boy's 20 GA sx4 by pulling out the bolt handle for disassembly. I failed to realize you need to depress that little stamp meatal tab in the bottom (shell stop) before you can pull the bolt handle out! So I ordered a new shell stop, my question is can I just drive the pin holding...

I have some H4350! I wonder where to start?

What’s your load? That’s some impressive speed, any pressure signs? I have a hard time finding load info.

I would run it right where it is! If its shooting that good I would let her fly, I usually try a load jammed ten tho into the lands during load development and have never personally noticed any increase in case pressure signs or velocity increase. Of course these have been cup and core bullets...

I just want to see for now what kinda speeds I can get out of the 220 swift AI. After I re-barrel I don't know If I want to fireform anymore. Maybe a standard 22-250 or maybe 22CM for heavy bullets for long range. Maybe even go with 6br and 105gn just to get maximum barrel life. Dad was the...

what speeds were you seeing and what barrel length?