Recent content by distantfoe

Sold

I have a McMillan 10/22 sporter stock that needs a new home. Unfortunately the project never got off the ground so this needs to go. McMillan Sporter stock - 10/22 inlet - 1" barrel inlet - comes with pillar installed - eschutzen included - not 100% sure of the fill but seems consistent with...

Proof the problem, but you’re lucky the outlier is usually a lot further out than that.

Oh the things I would do for a bag full of that brass.

Any difference in Astigmatism can’t help.

Trade pending

Any interest? If not, off to eBay.

Let’s try $2650 shipped

I have a Nightforce MOA Beast for sale. Have been hanging onto it in hopes of eventually building an elr rig. The scope hasn’t been used much with the exception of a x47 prs rig. It’s it very good shape with no imperfections in the glass and typical exterior scuffs including a rub mark on the...

I didn’t think they’d move neither until tapping the side/front of the base while the barrel was viced and a .0005 mic on the opposite end. Never thought a .5 ounce engraving hammer could do so much with little to no effort. Now every rig has either a pinned or milled into the receiver scope base.

Have a gunsmith add press pins and be done with it.

Let me guess, it’s either a button rifled barrel and/or carbon fiber?

Check with the smaller shops, their adg stock rarely dries up with prc, Ultra Mag, and Nosler calibers. Can’t go wrong with adg!

So I've worked up loads for several 30 Nosler hunting rigs built by various gunsmiths and had good luck using H1000, 215 Bergers, in ADG with velocity in the 3050-3125 range. All have shot well even in lighter configurations. The one thing that's bugged me with the different rifles has been...

Hmm, for that kind of money you’ll probably have better luck in the Texas panhandle with Rush Creek Outfitters. They’re good about making sure you’ll at least have an opportunity for that kind of money.