Recent content by Bolosniper

We use 2 of KG Industries products named KG-1 Carbon Cleaner and KG-12 Copper Remover in conjunction with Kano Laboratories Kroil Penetrating Oil. We liberally dose the bore after a range session and while still at the range with Kroil and let it soak until we are ready to clean the weapon...

I can't say that I have seen or shot one of the TC Icon rifles, but I can say that last week Mike Degerness (Advanced Barrel Systems) and I were on the phone and one of the topics he brought up was his acquisition a TC Icon. He said that it was a pleasant surprise to find that the rifle shot...

Here is a 300 Winchester Magnum on an AICS stock. Total weight of the rifle with a loaded 5 round magazine and one in the chamber, a Harris S-LM Bipod, and a 1.25" nylon sling with Uncle Mike"s QD sling swivels, and a 12-42X56mm NightForce scope is 11.1 lbs.

I have quite a bit of experience with Mike Degerness and with the quality (accuracy) of ABS barrels. Both are top notch. Mike is the "Mad Scientist", in a manner of speaking, behind the development of carbon fiber composite barrel technology, and has the patent to prove it. I refuse to say...

Have an Edwards Magnum Recoil Reducer (spring and weight design), and a Pachmayr Decel Pad (or a similar "soft" type pad) installed and that will tame the recoil of a lightweight, heavy hitting rifle. I also use a muzzle brake (Vias) on my 300 and 338 RUM rifles, and the recoil is equivalent to...

I use primarily Hodgdon H1000 and Retumbo due to the low standard deviation rate of these powders. I also work the loads up to the maximum pressure that I can safely shoot which is always, approximately, a couple of grains higher than the maximum recommended load because I have found that this...

Try Lost River Ballistic of Arco, Idaho. Telephone #888-807-8611 & websit address is http://www.lostriverballistic.com

We use Barney Lawton's actions and barrels. The barrels slug out perfect every time - no matter the contour, and the bore finish is excellent. All we have to do is to thread the tenon, chamber, crown and finish coat. The actions are, for me, a dream come true. I also hope that everyone...