Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
300PRC Reloading Advice
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="2buffalo" data-source="post: 2779129" data-attributes="member: 122577"><p>Doing what you are will probably get you there but in my opinion wasting time and components. At 100 yds I would do an OCW test with one powder in .5 grain increments until you hit pressure. This will allow you to do two steps in one. Then go seating depth and the final step would be neck interference. I have also just did a 300 PRC with seating depth with a middle range load first that worked fairly well. I started with N568 which worked well then Retumbo because I had more Retumbo than N568. They both produced about the same results.</p></blockquote><p></p>
[QUOTE="2buffalo, post: 2779129, member: 122577"] Doing what you are will probably get you there but in my opinion wasting time and components. At 100 yds I would do an OCW test with one powder in .5 grain increments until you hit pressure. This will allow you to do two steps in one. Then go seating depth and the final step would be neck interference. I have also just did a 300 PRC with seating depth with a middle range load first that worked fairly well. I started with N568 which worked well then Retumbo because I had more Retumbo than N568. They both produced about the same results. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
300PRC Reloading Advice
Top